Miter gear – changes transmission direction only
Miter gears are one type of bevel gears where the two rotational axes intersect. When speaking of narrow definition of bevel gears with ability to increase or decrease speed, miter gears do not have that ability due to the pair’s same number of teeth. Their purpose is limited to the change in transmission direction. Because they are a type of bevel gears, the basic characteristic of bevel gears exist such as presence of gear forms of straight cut, spiral cut and zerol types.
Also, because the shafts can be set to any angle, there are miter gears with non-90 degree (non-perpendicular) angle called angular miter gears. We are capable of producing angular miter gears with shaft angles in the range of 45 to 120 degrees.
Because a pair of straight tooth miter gears has the same number of teeth, with the exception of minor differences such as set screw holes and key ways, the same two gears can mate with each other. However, in the case of spiral miter gears, even when the number of teeth are the same, the twisting directions are different. Therefore, the same gear cannot be meshed together, and it is necessary to pair the right and left handed pairs.
Also, to produce straight tooth miter gears. KHK utilizes Coniflex made by Gleason Company that allows the use of crowning method as in making bevel gears which creates final products superior in quietness.
Incidentally, originally the hat worn by Catholic bishop is called mitre and in woodworking the word miter joint is used.
1.CAN YOU DO CUSTOMIZED PRODUCTS?
Yes,we are mainly doing customized products according to the customers’ drawings or samples.
2.HOW ABOUT THE CAPACITY OF YOUR COMPANY?
We have 12 modern types of energy-saving & environmentally-friendly production lines including a fully automated wax and shell making process flow line, as well as 4 heat treatment production lines. And our annual production capacity is over 20,000 tons.
3.HOW TO GUARANTEE THE QUALITY OF YOUR GOODS?
Firstly, We will do the inspection after every process.For the finished products,we will do 100% inspection according to the customers’ requirements and the international standard.Secondly,we have our own testing lab and the most advanced and complete inspection equipment in the casting industry,including Spectrometer, Metallographic Microscope, Tension Tester, Low Temperature Tester, X-ray Tester, MPT, UT, CMM, Video Measurement Machine and so on.With these advanced facilities & instruments, we are able to supply the most precise finished products to our customers, and make products meeting their overall inspection requirements on chemical composition, mechanical properties, non-destructive testing and high precise dimensional inspections.