Contact Us
Fax:+86-571-88220227
Mail:[email protected]
Add:No. 2, Longshen Cdc, Sandun Town, Hangzhou, Zhejiang, China
Chain wear failure causes conveyor chain failure
Failure due to wear is a common and obvious manifestation. There are many reasons for this failure. The main reason is poor chain material and improper operation by workers. Chain whole
The parts that are prone to wear are the sprocket and the pin. The wear of these two parts is mainly due to insufficient local lubrication, so in order to avoid this phenomenon, the operator should pay attention to frequent inspections
Lubrication effect, add lubricating oil in time, check whether there is abrasive in the lubricating oil or change the lubrication method. After the sprocket is slightly worn, the sprocket can be reversed so that the side with the lighter wear faces the chain
Article. In addition, if the use environment is bad or the lubrication and sealing is not good, it will cause the hinge to wear. Once the chain hinge is worn out, the chain link becomes longer, and it is easy to cause tooth jumping or slip
The chain reduces the service life of the chain and accelerates the failure of the chain.
Related Industry Knowledge
- What to pay attention to when choos...
- How to reduce wear on circular chain
- What are the reasons why the liftin...
- How to maintain and maintain the chain
- What aspects of chain inspection ne...
- The development of my country's cha...
- What should be paid attention to wh...
- Commonly used heat treatment method...
- Common problems of gear reducers an...
- Gear manufacturer's production process
- Mechanical parts that transmit motion
- Analysis of sprocket manufacturers:...
- The bearing capacity of the gear ma...
- Working principle of speed changer
- The difference between inverter and...