Contact Us
Fax:+86-571-88220227
Mail:[email protected]
Add:No. 2, Longshen Cdc, Sandun Town, Hangzhou, Zhejiang, China
The micro-oil screw air compressor is an indispensable air compressor for the plastic products industry such as blown film and hollow.
(1) Filtration, enter the multi-function intake control valve.
(2) Then the clean air enters the rotor driven by the motor for compression. Precise control of a certain amount of cooled compressor oil is continuously injected into the screw. The heat generated by the compression is taken away during the compression process. A small fit clearance between the two opposing rotating screws and the rotor chamber is sealed. It also serves to lubricate the rotor bearings.
After the compression is completed, the oil-containing air is discharged from the handpiece (4). The -flange connection directly enters the bedroom oil and gas pre-separation vessel (5) without any pressure loss. In this case, the compressed air is buffered and the speed is rapidly reduced. The oil in the compressed air is precipitated and separated due to the action of gravity and the speed. After the separated compressed air passes through the screw-in fine oil separator (6), the oil content in the compressed air is only 1-3 mg/m3. The separated compressed air is cooled by a minimum pressure check valve (7) to an air cooler (9).
The cooled compressed air enters the gas system through a shut-off valve.
The oil separates and settles in the pre-separation vessel, and the oil foam is rapidly reduced and sent to the enlarged oil cooler (8). The filtered, cooled oil is re-injected into the head. The oil is filtered through the oil filter (10) and recycled without contaminating the system.
The thermostatic valve (11) ensures that all screw air compressors operate at optimum temperatures for all operating phases.
Related News
- How To Choose The Motor Reasonably ...
- What Is The Motor Carbon Brush
- Basic Of Oil-free Screw Air Compressor
- The Difference Between The Sprocket...
- Daily Maintenance Of The Jack
- The Correct Use Of The Jack
- Where Is The Jack Placed In The Car
- How To Improve The Efficiency Of Th...
- What Are The Sprocket Designs That ...
- Sprocket Installation Requirements ...
- Micro Oil Screw Air Compressor
- How The Gearbox Works
- What Is The Difference Between A Ge...
- The Low Noise Era Of Geared Motors ...
- Evaluation Of Magnetic Defects In G...
- What Are The Ways To Gear Machining
- Choosing A Good Gear Reducer Is Ver...
- Speed Ratio Of Hard Gear Reducer
- Gear Reducer
- Coal Mine Machinery Gear Tooth Surf...